Makita HR2631F Manual De Instrucciones página 7

Hook
For Model HR2641
CAUTION:
• Never hook the tool at high location or on poten-
tially unstable surface.
► 1. Hook
The hook is convenient for hanging the tool temporarily. To use
the hook, simply lift up hook until it snaps into the open position.
When not in use, always lower hook until it snaps into
the closed position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Side grip (auxiliary handle)
2
► 1. Protrusions 2. Grooves
CAUTION:
• Always use the side grip to ensure operating safety.
Install the side grip so that the protrusions on the grip fit
in between the grooves on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360°so as to be secured at any position.
1
1
Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and lon-
ger service life.
Installing or removing the bit
1
► 1. Bit shank 2. Bit grease
Clean the bit shank and apply bit grease before install-
ing the bit.
1
► 1. Bit
Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1
► 1. Bit 2. Chuck cover
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
7 ENGLISH
2
2