Makita HR2631F Manual De Instrucciones página 8

Bit angle (when chipping, scaling or
demolishing)
► 1. Action mode changing knob
The bit can be secured at the desired angle. To change
the bit angle, rotate the action mode changing knob to
the O symbol. Turn the bit to the desired angle.
Rotate the action mode changing knob to the
Then make sure that the bit is securely held in place by
turning it slightly.
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth.
3
1
► 1. Grip base 2. Lock button 3. Depth gauge
Press the lock button on the grip base in the direction of arrow
shown in the figure and with the lock button being pressed
insert the depth gauge into the hex. hole in the grip base.
1
► 1. Toothed side of hex hole marking on the grip
At this time, the depth gauge needs to be inserted so that
its toothed side is directed to the toothed side of hex hole
marking on the grip base as shown in the figure.
symbol.
► 1. Lock button
Adjust the depth gauge to the desired depth by moving
it back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth gauge.
2
► 1. Toothed side of hex hole marking on the grip
8 ENGLISH
2
base 2. Toothed side of the depth gauge
1
base 2. Toothed side of the depth gauge
NOTE:
• Inserting the depth gauge with its toothed side
not directed to the toothed side of hex hole
marking on the grip base as shown in the figure
does not allow the depth gauge to be locked.
1
1
2