Idiomas disponibles
Idiomas disponibles
Thrust plate
A
60 mm (2.4 in) diameter (A) version
–
for mounting mowing heads and
grass cutting blades
65 mm (2.6 in) diameter (A) version
–
for mounting brush knives and
circular saw blades
NOTICE
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
Thrust washers
A
60 mm (2.4 in) diameter (A) version
–
for mounting grass cutting blades
and circular saw blades
70 mm (2.8 in) diameter (A) version
–
for mounting brush knives
FS 510 C, FS 560 C
Rider plates, guard ring and nut
A
Approximately 80 mm (3.2 in)
–
diameter (A) rider plate (1) for grass
cutting blades
Approximately 63 mm (2.5 in)
–
diameter (A) rider plate (2) for
circular saw blades
4
3
Guard ring (3) for brush knives.
–
Both these parts have the same
function:
Nut (4) and thread on shaft are
A
–
protected against wear.
Ground contact with metal cutting
–
attachment is minimized.
Rider plate allows cutting
–
attachment to glide along close to
ground.
WARNING
Always replace a worn rider plate and
guard ring in good time.
A
A
Nut and combination wrench
5
4
Metal cutting attachments are mounted
to the gearbox with the nut (4).
Loosen and tighten the nut (4) with
N
the combination wrench (5).
WARNING
If the mounting nut has become too
loose, fit a new one.
Cleaning the Gearbox and Cutting
Attachment Mounting Hardware
Clean the gearbox, the area surrounding
it, inside the grass shield and the cutting
attachment mounting hardware at
regular intervals. Also check for
contamination when changing the
cutting attachment and clean thoroughly
if necessary.
Remove all cutting attachment
N
mounting hardware from the
gearbox for this purpose.
English
25
