Idiomas disponibles
Idiomas disponibles
This device becomes hot
This device releases the heat from inside through the case. The surface of the case will be hot, but
it is normal. Even when the power is off, the device is still warm due to the standby current. If the
heat stays in the case, this device may malfunction.
• Do not place any object which blocks heat around or on top of this device.
• Do not cover this device with such as a cloth.
* Mac OS X may not recognize this device at boot. If this happens, unplug the USB cable, then plug it
again after a few seconds.
* If your Windows computer will not boot while this drive is connected, then connect the drive to your
computer after rebooting Windows. Also, refer to your computer's manual to change the BIOS setting to
boot from an internal hard drive if you want to turn on or off your computer while this unit is connected.
* This unit supports hot-plugging. You can plug or unplug the USB cable while this unit or your PC is
on. However, never unplug the USB cable while the power/access LED is flashing, or your data may be
lost or damaged.
* Always refer to your PC and peripheral devices.
* Booting your PC from the DriveStation is not supported.
* Do not lean any object against the DriveStation. It may cause the unit to malfunction.
* If you use this unit with Windows 7, Vista, or Windows XP on a computer with a USB 2.0 or 1.1 port,
you may receive a message indicating that a high-speed USB hub is connected to a non high-speed
USB device. To continue, click [X].
* The cooling fan inside the DriveStation operates only if the internal temperature becomes high.
* You may hear some noise while this unit is working, especially while booting or being accessed. This
is normal.
* When the drivers for this unit are installed, devices are added to Device Manager.
To display Device Manager, follow the instructions below:
On Windows 7/Vista ..............................Click [Start], right click [Computer], and click [Manage]. When "A program
Windows XP .............................................Click [Start] and right-click [(My) Computer]. Click [Manage], then [Device
Location
Universal Serial Bus controllers
Disk drives
*
displayed once if the DriveStation is locked or twice if it's unlocked.
4
HD-HXU3 User Manual
needs your permission to continue" is displayed, click [Continue] or [Yes], then
[Device Manager].
Manager]
Added Device
USB Mass Storage Device
BUFFALO HD-HXU3 USB Device *
