Flex Base Wires Inward
Tubes de la base courbés vers l'intérieur
Flexionar cables de base para adentro
4
• While flexing the base wires toward each other,
hook the footrest onto the ends of the base wires.
• Push the footrest down completely to the tabs on
the base wires.
• Tout en courbant les tubes de la base l'un vers l'autre,
glisser le support du repose-pieds sur l'extrémité
des tubes.
• Pousser le repose-pieds complètement vers le bas,
jusqu'aux butées des tubes de la base.
• Mientras flexiona los cables de la base uno hacia el otro,
enganchar el reposapiés en los extremos de los cables
de la base.
• Empujar el reposapiés hasta abajo a las lengüetas de
los cables de la base.
Assembly
Assemblage
Tabs
Pattes
Lengüetas
Montaje
/
"
#8 x
(1.9 cm) Screw
3
4
Vis n° 8 de 1,9 cm
Tornillo N°8 x 1,9 cm
Base Wire
Tube de la base
Cable de base
5
• Position the seat back tube above the base assembly.
• Fit the seat back tube completely onto the base wires.
• Fit a retainer (rounded side inward) to one end of the
seat back tube.
• Insert a #8 x
/
" (1.9 cm) screw through the outside
3
4
hole in the seat back tube and into the retainer. While
holding the retainer in place, tighten the screw.
• Repeat this procedure to secure the other side of the
seat back tube to the base assembly using the remaining
retainer and #8 x
3
• Pull up on the seat back tube to be sure it is secure.
If you can remove either end of the seat back tube,
you have not assembled it correctly. Remove the screws
and retainers. Re-read and repeat Assembly step 5.
8
Retainers
Bagues de retenue
Retenedores
Seat Back Tube
Tube du dossier
Tubo del respaldo
Base Wire
Tube de la base
Cable de base
Pull Up
Tirer
Jalar para arriba
/
" (1.9 cm) screw.
4
