Idiomas disponibles
Idiomas disponibles
Installing shear blades
2
3
4
► 1 . Cutting head 2. Sleeve 3. Side blade R 4. Center
blade 5. Side blade L 6. Screws
Install the sleeve and tighten the three screws after
inserting the center blade, side blade L & R into the
cutting head. In this process, the screw heads should
be protruding 2 - 3 mm from the cutting head surface.
If you will tighten the screws excessively, the cutting
head cannot be installed to the tool.
Installing cutting head
CAUTION:
•
Secure the cutting head firmly. Otherwise it can
rotate during operation and can cause serious
injury.
1
2
3
► 1 . Cutting head 2. Screws 3. Hex wrench 4. Tighten
Insert the cutting head into the tool with turning it left
and right alternately. Then tighten the three screws with
the hex wrench.
1
6
5
4
Replacing cutting head for capacity
of gauge 16 (Optional Accessory)
1.
Remove the cutting head. (Refer to the section
titled " Removing cutting head ".)
2.
Loosen the bearing assembly with provided
wrench while keeping the spindle still by grabbing
the two flat parts on the spindle still with another
wrench.
3.
Remove the bearing assmbly (thin one) and screw
the bearing assembly for gauge 16 onto the spin-
dle and firmly tighten it with the provided wrench
while keeping the spindle still by placing another
wrench on the two flat surface on the spindle.
4.
Install the optional cutting head by referring to the
section titled " Installing cutting head ".
CAUTION:
•
Do not confound the bearing assembly pro-
vided on the tool (thin one) with that for cut-
ting head for capacity of gauge 16 (Optional
Accessory). The bearing assembly provided
on the tool is thin while that for cutting head for
capacity of gauge 16 (Optional Accessory) is
thick.
7 ENGLISH
