Idiomas disponibles
Idiomas disponibles
The Hayward Water Bowl is a bowl-shaped water feature containing an LED light that together cre-
ate a stunning flickering fire effect designed to enhance your backyard pool or spa experience. The
Water Bowl must be installed as specified by these instructions. Please follow ALL of the instructions
enclosed with this unit. It is recommended to keep the unit in its original packaging until the site is
prepared for installation.
What's Included
Item #
Sold Separately
Part Number
LBCUS11100L
LBCUS11150L
LBCUS11100LP
LBCUS11150LP
Preparation
Determine the install location(s) for the Water Bowl. Be sure to follow all NEC and local codes during
installation.
For optimal performance, the lip of the bowl should slightly hang over the edge of the
pool or spa.
The electrical junction box and/or low voltage swimming pool transformer should be
located at least
48 inches
8 inches
above the bowl's water level.
Once you have determined the install location(s), gather all necessary tools and refer to the following
sections to rough-in plumbing and electrical lines.
Overview
Refer to the diagram on the following page for a basic installation overview. Note that the plumbing
for the Water Bowl requires a check valve to prevent drain off when the system is not in use. A flow
control valve should also be used in order to obtain the optimal water effect in the bowl.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Introduction
Part Description
1
Bowl Assembly (round or square)
2
Water Spout Assembly
LED Light and Niche Assembly 100'
LED Light and Niche Assembly 150'
LED P Light and Niche Assembly 100'
LED P Light and Niche Assembly 150'
Installation
from the edge of the pool or spa and at least
Part Description
Quantity
1
1
Quantity
1
1
1
1
4 inches
above ground and
2
2
