Idiomas disponibles
Idiomas disponibles
Step 5: Set LED Light in Niche
With wiring complete, the LED light is ready to be set in the niche. Seal the gap around the power
cable in the electrical line in the niche using the rubber grommet that is pre-installed on the power
cable. Once sealed, gently set the LED light assembly onto the ribs in the niche so it is seated
properly. IMPORTANT: Since the bowl will rest on top of this surface, make sure that the LED light
assembly is seated properly so it is not damaged.
Bowl Installation
Refer to graphic below and the following steps for bowl installation.
Step 1 - For Glass Bowl Installations: When installing a glass bowl, the use of a base pad is
recommended to prevent damage to the bowl. Place the base pad over the niche collar as shown on
the following page. For square bowl installations, make sure that the edge of the base pad is aligned
with the edge of the pool deck.
9
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Water Spout Assembly
Bulkhead Assembly
Water Supply Pipe
Bowl
Base Pad (for use
with glass bowls)
