Idiomas disponibles
Idiomas disponibles
To change the light mode, follow the procedure below.
1. Turn on the light(s)
2a. Quickly toggle the light OFF and then ON, 17 times. This will put the light into P-mode.
2b. Quickly toggle the light OFF and then ON, 15 times. This will put the light into Water Fire mode.
Manual Control
Turn on power to the pump controlling the Water Bowl system as well as the switch for the LED
light(s). Adjust the flow control valve(s) until the ideal water effect is achieved in the bowl.
When using a wall switch to control the light, the light must be set to UCL (Universal ColorLogic)
mode. This will allow the light to be controlled through power-cycling. The light should already be set
to UCL mode from the factory but if the light mode needs to be set, see the procedure on page 12.
To activate the light, simply turn on the switch powering the transformer. To deactivate the light, turn
off the switch. To advance to the next light program (fixed color or color show), turn the switch off,
then back on again within 10 seconds.
When the light has been off for over 60 seconds, and is first turned on, it will come on in white for
15 seconds for quick clear view of your pool, then go to the last fixed color or color show that was
running. Note: Do not power cycle the light during the first 15 seconds of white to preclude risk of
loss of synchronization with other connected lights.
When in UCL mode, the light has the capability to display 17 different programs; 10 fixed colors
and 7 color-changing shows. These programs are advanced using power-cycling − quickly toggling
power to the light. The programs are listed below:
1.
Show-Voodoo Lounge
2.
Fixed-Deep Blue Sea
3.
Fixed-Royal Blue
4.
Fixed-Afternoon Skies
5.
Fixed-Aqua Green
6.
Fixed-Emerald
If you have multiple lights running together and they become out of sync, you can resync the lights
by following the steps below:
1.
Turn lights on.
2.
Turn the lights OFF for between 11-15 seconds, and then back ON.
Omni Automation Control
When using an Omni controller, the light can be set to Omni Direct mode which allows for direct
toggling to the selected show/color as well as 10 additional fixed color options, brightness control,
and speed control. Refer to the Configuration section of your Omni controller manual for instructions
on configuring a light and configuring a water feature. Note that the light mode can be changed from
the configuration menu of the Omni control, but if the mode needs to be changed manually, follow
the procedure on the following page.
11
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
(LBCUS11100L & LBCUS11150L)
7.
Fixed-Cloud White
8.
Fixed-Warm Red
9.
Fixed-Flamingo
10. Fixed-Vivid Violet
11. Fixed-Sangria
12. Show-Twilight
(LBCUS11100L & LBCUS11150L)
13. Show-Tranquility
14. Show-Gemstone
15. Show-USA
16. Show-Mardi Gras
17. Show-Cool Cabaret
