Bras B-frozen 6 Manual De Instrucciones página 16

B - f r o z e n 6 & 1 0
7. 4 CLEANING
1 Cleaning and washing are essential to guarantee the
perfect preservation of the taste of the product and the
maximum efficiency of your dispenser. The procedures
described below should be considered general in nature and
may vary due to the health regulations in force.
2 Before disassembly for washing, the dispenser must be
emptied out of the product. Proceed as follows:
- use the keypad to select the CLEANING operating mode
- if necessary, wait until the product becomes liquid
- remove the flow restrictor from the container (see figure 12)
- place a container under each tap and empty the containers
- fill the containers with water and allow the dispenser to
operate in CLEANING mode for a few minutes. Then empty the
containers.
- hold down key A to switch off the dispenser
- turn the ON/OFF SWITCH to OFF
7. 4. 1 DISASSEMBLING THE RECOVER (OP-
TIONAL)
1 Place the right-hand part of the recover on a surface. Place
the container inside it.(see figure 2)(see figure 3).
2 Put the left-hand part of the recover into position and make
sure that it fits into the illustrated groove. Click the two parts
figure 2
figure 3
together. (see figure 4)(see figure 5).
7. 4. 2 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the device from the mains.
1 To remove the lid of the container, press the top button and
slide the lid towards the front of the container.
If there is a safety lock for the lid, turn the key in an anti-
16
figure 4
figure 5