Idiomas disponibles
Idiomas disponibles
GETTING TO KNOW YOUR CLEANER
A.
Handle
B.
Permanent Exhaust Filter
C.
ON/OFF Button
D.
Bag Door
E.
Bag Door Realease Button
(GP)
F.
Carpet and Hard Floor Nozzle**
G.
screw
H.
Carry Handle
I.
Rotating Upper Cord Hook
J.
Power Cord
K.
Lower Cord Hook
L.
Parquet Nozzle*
GETTING TO KNOW YOUR CLEANER
Remove all components from the packaging.
• Assemble the cleaner handle and fix in position with the supplied screw. [1,2]
• Open the bag door and check if the dust bag paper is correctly fitted. [8.1]
• Ensure the pre-motor sponge filter is correctly fitted. [9]
• Fit the Carpet and Floor Nozzle. [3]
USING YOUR CLEANER
POWER CORD STORAGE
Before use undo integrated clip, turn top hook and release power cord. [5]
1.
During use as a stick cleaner clip power cord into back of main handle. [6]
2.
After use, unclip power cord from handle and wind it around storage hooks before
securing with integrated clip.
CONTROLS
On/Off switch. Push to switch On. Push again to switch Off. [7]
1.
CLEANER MAINTENANCE
BAG & FILTERS
IMPORTANT: switch cleaner Off and remove plug from electricity supply before changing
paper bag or removing any filters.
CHANGING THE BAG
Lay the cleaner on a flat surface, pull back catch and remove bag door. [8.1]
1.
2.
Remove bag by pulling bag collar from hose inlet. Remove sticky backing from the
dust flap and fold it over the inlet to avoid dust escaping from the bag. [8.2]
Before fitting a new bag, fold the corners of the bag behind the collar. [8.3]
3.
4.
slide the collar along the guides and lift over the inlet tube. Collar should 'click' into
place. [8.4]
Locate tabs on bag door as shown and close bag door. [8.5]
5.
Replace the bag frequently when picking up material such as powder or fine dust or when
cleaning new carpets.
DO NOT overfill the bag.
DO NOT use the vacuum cleaner without a bag in place.
IMPORTANT: Hoover recommends that filters are replaced after five full bags have been
used.
REPLACING THE STANDARD PRE-MOTOR FILTER [9]
With bag removed lift the pre-motor filter from the bag housing.
Fit the new filter and replace the paper bag.
DO NOT use the vacuum cleaner without the pre-motor filter in place.
Replace the standard pre-motor filter after five full bags have been used.
SPECIALITIES
NOZZLES
1.
Carpet & Floor nozzle
Press the Floor type selector pedal on the nozzle [4] to select the ideal cleaning
mode for the floor type.
Hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for the deepest clean.
2.
Parquet nozzle* for wooden and delicate floors.
ACCESSORIES
To obtain the best performance and energy efficiency #1 it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
2
*Certain Models Only
GB
**Nozzle design may vary according to models
