Idiomas disponibles
Idiomas disponibles
WARNING
Always sharpen blades on a regular basis. Failure to
do so will cause the machine to underperform and
will overload engine and bearings causing machine
breakdown. Blades must not be sharpened beyond
the wear mark (see diagram). Failure to comply with
this could result in machine damage, injury or loss of
life.
Tension belts
NOTE: There will normally be a rapid drop in tension during run-in period for new belts. When new
belts are fitted, check the tension every 2- 3 hours and adjust until the tension remains constant.
Belt failures due to lack of correct tensioning will not be covered under your warranty.
Tension drive belts
1) Remove belt guard.
2) Loosen bolt in centre of tensioner pulley with a 19mm spanner so that pulley is able to slide
with minimal wobble.
3) Turn nut in end of tensioner pulley slider until correct belt tension is achieved. For
instructions on checking belt tension & correct belt tension values, please refer to the V-Belt
Tensioning Data Table.
4) Retighten bolt in centre of tensioner pulley.
5) Refit belt guard.
6) Run machine and test, recheck belt tension.
NOTE: Slack drive belts will cause poor performance and excess belt and pulley wear.
