Idiomas disponibles
Idiomas disponibles
A
Two hydraulic motors are fixed on the feeding roller and rotate in opposite directions to roll the
wood into the chipping house.
B
When put the control valve handle to the middle position, hydraulic motors will not rotate, and wood
will not move.
C
When push the control valve handle in to the inner position, hydraulic motors will rotate reversely,
then the wood will be returned back.
Starting to chip
WARNING
Do not use or attempt to start the chipper without the protective guarding and
discharge unit securely in place.
Failure to do so may result in personal injury or loss of life.
•
Check that the chipper is running smoothly.
Release the catches on the feed tray and lower. Pull to release the red stop button.
•
•
Perform the "before using the chipper" tests.
•
Stand to one side of the feed funnel.
Proceed to feed material into the feed funnel.
•
Chipping
Wood up to the recommended diameter can be fed into the feed funnel. Put the butt end in first and
engage it with the feed rollers. The hydraulic feed rollers will pull the branch into the machine quite
quickly. Large diameter material will have its feed rate automatically controlled by the no stress unit.
