Idiomas disponibles
Idiomas disponibles
•
If acid is swallowed, consult a doctor immediately.
WARNING NOTES: THE BATTERY CASE CAN BECOME BRITTLE, TO AVOID THIS:
Do not store batteries in direct sunlight.
•
Discharged batteries may freeze up, therefore store in an area free from frost.
•
DISPOSAL:
Dispose of old batteries at an authorised collection point.
•
Follow the transport instructions.
•
Never dispose of old batteries in household waste.
•
Storage and transport
Batteries are filled with acid.
•
Always store and transport batteries upright and prevent from tilting so that no acid can
•
escape.
Store in a cool and dry place.
•
•
Do not remove the protective cap from the positive terminal.
Run a FIFO (first in-first out) warehouse management system.
•
1. Initial operation
•
The batteries are filled with acid at a density of 1.28g/ml during the manufacturing proces
and are ready for use.
•
Recharge in case of insufficient starting power.
2. Installation in the vehicle and removal from the vehicle
Switch off the engine and all electrical equipment.
When removing, disconnect the negative terminal first.
•
Avoid short circuits caused by tools, for example.
•
Remove any foreign body from the battery tray, and clamp battery tightly after installation.
•
Clean the terminals and clamps and lubricate slightly with battery grease. When installing,
first connect the positive terminal, and check the terminal clamps for tight fit.
•
After having fitted the battery in the vehicle, remove the protective cap from the positive
terminal, and place it on the terminal of the replaced battery in order to prevent short
circuits and possible sparks.
•
Use parts from the replaced battery, such as the terminal covers, elbows, vent pipe
connection and terminal holders (where applicable); use available or supplied filler caps.
•
Leave at least one vent open, otherwise there is a danger of explosion. This also applies
when old batteries are returned.
3. Charging
•
Remove the battery from the vehicle; disconnect the lead of the negative terminal first.
•
Ensure good ventilation.
•
Use suitable direct current chargers only.
•
Connect the positive terminal of the battery to the positive output of the charger. Connect
•
the negative terminal accordingly.
•
Switch on the charger only after the battery has been connected and switch off the charger
first after charging has been completed.
•
Charging current recommendation: 1/10 ampere of the battery capacity Ah.
•
Use a charger with a constant charging voltage of 14.4V for re-charging.
