Idiomas disponibles
Idiomas disponibles
GB
MT
with the blower pipe as close to the
ground as possible.
Fitting the flat nozzle (optional)
• Slide the flat nozzle (12) onto the blow-
er pipe (4).
The button (16) on the blower pipe (4)
must slide into the guide rail (5) on the
flat nozzle (12).
There are 3 possible settings for the flat
nozzle (12).
The device can be set to your in-
dividual working height via these
3 settings. You should always work
with the blower pipe as close to the
ground as possible.
Removing the blower pipe
• Press the lock (7) and remove the blow-
er pipe (4) and the attachment (6).
Removing the attachment
• Remove the attachment (6) from the
blower pipe (4) by sliding it out of the
guide rail (5).
Removing the flat nozzle
(optional)
• Remove the flat nozzle (12) from the
blower pipe (4) by sliding it out of the
guide rail (5).
Putting on the carrying
strap
Never wear the carrying
strap diagonally across your
shoulders and chest: only
wear it on one shoulder to
ensure you can detach the
device quickly from your
body in the event of danger.
Pulling the push-fit lock (
leases the device quickly from the
carrying strap. To open the push-fit
lock, press the two clamps together.
32
1. Place the carrying strap (
shoulder.
2. Adjust the strap length so that the snap
hook is approximately 10 cm below
your hip.
3. Attach the snap hook on the carrying
strap (
hook in the strap. This is located on the
top of the device.
Operation
protective equipment and work
gloves while working with the de-
vice. Prior to each use, ensure that
the device is working correctly.
Ensure that the device has been
mounted properly.
Stop using the device if the On/Off
button is damaged.
Personal protective equipment and
a fully functional device reduce the
risk of injuries and accidents.
wheel continues moving for some
time. Injury hazard caused by ro-
tating tool!
14) re-
13) at the fixing lug (17) to
Caution! Risk of injury!
Always wear appropriate
After the device has been
switched off, the turbine
Observe noise protection rules and
other local regulations.
Switching on and off
The leaf blower may only be used
with two batteries of the Parkside
X 20 V Team series.
Before switching the device on,
make sure that it is not touching any
objects. Ensure secure positioning.
13) on one
