Idiomas disponibles
Idiomas disponibles
Receivers
Warning! The receivers must only be powered by a safety power pack. The use of non-safety power
packs could provoke damage to the system.
FASTENING THE OUTDOOR RECEIVER IP55 (fig. 4, pag. 59)
Open the four fastening holes as shown in the drawing using a screwdriver of similar tool. Trace the four wall
fastening points using the container as a template and then drill the holes (det. 3-4). Fasten the container
using four self-tapping screws M4,8 (det. 5). Once the container has been fastened insert the screw covers.
Remove the cable clamp covers and affix the two cable clamps as shown in detail 6.
Outdoor receivers (fig. 5)
The outdoor receiver is fitted with a 13-way terminal board and has a 12/24V ac-dc electrical connection
between binding posts 1-2.
Interchangeable channel modules - MCCMORPHM0
In the receivers the channel functions are printed on the circuit board near the module's slot-in position: insert
the module or modules into the slots that correspond to the channels you intend to use.
The modules are set via dip-switches (Dip1=CHA - Dip2=CHB - Dip3=CHC - Dip4=CHD) to the following:
- Impulsive modules = dip-switch set to 'OFF' - ON/OFF modules=dip-switch set to 'ON'
Slot-in receiver cards (fig. 6)
Warning! The receiver cards must be sufficiently insulated from the parts of the host device, which are
powered by the mains.
The receiver card is inserted directly into an appliance, which is designed to receive it and has the following
electrical connections: 24V ac-dc between binding posts 3-4.
The receiver is fitted with two relays the outputs of which are marked CH1 (normally open contact) and CH2
(normally open/normally closed contact). To associate the channels CHA, CHB, CHC, CHD on the transmitters
to the relays CH1 and CH2 use jumper J1 located on the circuit board (e.g. fig. 6 - CHA = CH1 and CHB = CH2).
The channel relays can be set using the jumpers SEL CH1 and SEL CH2 as follows:
- ON/OFF relay = Jumper inserted - Impulsive relay = Jumper not inserted
14
