Idiomas disponibles
Idiomas disponibles
PREPARING THE SYSTEM
To obtain the best results from the radio control system the aerial installation site should be carefully chosen. 'Range'
is intended to mean the working distance, measured in free space, between the receiver and the transmitter with
the aerial installed. The range is therefore closely linked to the technical characteristics of the system and varies
according to the characteristics of the site in which the system is located. For best
to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial to the receiver using a coaxial cable RG58
(impedance 50Ω) with a maximum length of 15 m.
Transmitters
The transmitter is pre-coded and is fitted with an integrated circuit which is programmed in the factory
with a unique identification number. All the code parameters are contained in this integrated circuit. The
transmitter has an automatic shut down mechanism which cuts in after at least 20 seconds of continuous
use (this limits battery consumption).
Key block function
• A key block function has been added to protect the appliance from
accidental activation;
- to activate the function press and hold down "MR" for 8 seconds until
the orange led starts flashing, at this point to activate a command you
will need to press the required key three times consecutively;
- to reset the function to standard operation, press and hold down "MR"
for 8 seconds until the orange led starts flashing.
Transceivers
The transceivers are fitted with a buzzer which sounds to confirm the execution of the command and red
and green led lighting indicates the status of the relay (green = open, red = closed).
13
performance we advise you
1
2
MR
