Idiomas disponibles
Idiomas disponibles
Place the fridge door on the lower hinge, making sure that the hinge pin is
inserted in the hole at the bottom of the fridge door.
6. Put the middle hinge back on the cabinet, making sure that it is on the
opposite side from its original position.
7. Place the freezer door on the middle hinge, making sure that the hinge pin
is inserted in the hole at the bottom of the freezer door.
8. Remove the hinge pin from upper hinge. Turn the hinge plate over and
replace it in the same hole (reversed). Refit the upper hinge. Do not fully
tighten the screws.
9. Check that doors are aligned horizontally and vertically and that all seals
make good contact with the cavity all the way around the cavity opening
before finally tightening the hinges. Refit the plastic insert on the top cover
from left side to right side before re-fitting the top cover. Re-adjust the
levelling feet, if necessary.
Troubleshooting Guide
Temperature inside the compartments is not low enough.
Is food preventing the doors from closing properly?
Is the thermostat setting correct?
Are the air circulation vents blocked?
Temperature inside the refrigerator compartment is too low.
Is the thermostat setting correct?
The appliance is excessively noisy.
Has the appliance been installed correctly?
Are the pipes at the back touching or vibrating?
It is normal to hear the noise of the refrigerant liquid in circulation.
The appliance is not working?
Is there a power failure?
Is the plug properly inserted in the socket?
Has the fuse blown?
Is the power cord damaged?
Water collects at the bottom of the refrigerator compartment.
Is the thermostat setting correct?
Is the defrost water drain blocked?
The inside light is not working.
Perform the checks for point 4, and then:
Disconnect the appliance from the mains power supply.
If necessary replace the bulb with a new one (220÷240V, 10 Watt).
27
ENGLISH
