Chicago Pneumatic CP 0122 SL Instrucciones De Seguridad Y De Funcionamiento página 17

CP 0122 S, CP 0122 SL, CP 0125 S
♦ For the machine to maintain the specified
vibration values, always check the following:
Too large a clearance between the insertion tool s
shank and the chisel bushing will generate
increased vibrations. To avoid getting exposed to
excessive vibrations, check the chisel bushing for
wear every day.
If the machine has a vibration-absorbing
♦
handle/handles, check that it moves freely (up
and down) and does not jam.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Make sure that all the attached and related
♦
equipment, such as hoses, water separators and
oilers are properly maintained.
Periodic maintenance
After each operating period of approximately 150
impact hours or twice a year the machine must be
dismantled and all parts be cleaned and checked.
This work must be performed by authorised staff,
trained for this task.
9800 0832 90b | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Assembly instructions
Torque: 50-60 lbf.ft (68-81 Nm), use Loctite®
A.
243™ (Loctite is a registered trademark of
Henkel Corporation. 243 is a trademark of
Henkel Corporation.)
B. Torque: 400 lbf.ft (542 Nm).
C. Torque: 52 lbf.ft (70 Nm).
Troubleshooting
If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
Check that the insertion tool being used has the
♦
correct shank dimension.
Check that the pneumatic machine is getting the
♦
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or
uneven performance.
Check that the compressed air system supplies
♦
the machine with sufficient air pressure to give
full power.
♦ Check that the dimension and length of the air
hose are according to the recommendations. See
"Installation".
17