Installation - Stihl RMI 422 PC-LF Manual De Instrucciones

English
Mowing events: The total number of mowing
operations performed will appear on the status
screen.
Mowing hours: The total duration of all mowing
operations performed will appear on the status
screen.
Distance: The total distance traveled will appear on
the status screen.
Signal strength: Signal strength of the cellular
connection with network ID.
A small "x" indicates that the robotic mower is not
connected to the Internet.
Signal strength: A question mark is shown during
initialisation of the cellular module (checking
hardware and software, e.g. after switching on the
robotic mower).
GPS reception: GPS coordinates of the robotic
mower.
Time
Set the current time.
Always set the correct time to ensure an accurate
mowing plan and to prevent automatic mowing at
unwanted times.
The time can also be set using the iMow App.
Date
Set the current calender date.
Always set the correct date to ensure an accurate
mowing plan and to prevent automatic mowing at
unwanted times.
The date can also be set using the iMow App.
Date Format
Set your desired date format.
56
Track offset
Change the robotic mower's standard 2.36 in. (6 cm)
offset from the perimeter wire to a smaller or larger
offset (1.18 in. to 3.54 in. (3 cm to 9 cm)).
To ensure optimal performance under the standard
setup instructions, STIHL recommends that you keep
the default track offset setting.
Language
Set the desired display language. The language
selected during initial installation is set as the default.
Contrast
Change the display's contrast.
Energy mode
If the mode is set to "Standard" (default setting), the
robotic mower is connected to the Internet at all times
and can be reached using the iMow App as long as
sufficient battery charge is available.
If the mode is set to "ECO," cellular communication is
deactivated when the robotic mower is in the docking
station to reduce energy consumption. The robotic
mower cannot be reached using the app, which will
continue to display the last data successfully
transmitted.

15.3 Installation

Passage (Offset Drive Home)
The robotic mower can travel back to the docking station
with an increased offset to the perimeter wire.
► Ensure that the perimeter wire has been routed with a
clearance of at least 2 m at the narrowest sections.
► Activate the passage setting to change the way the robotic
mower travels back home to the docking station. Select
one of three options:
15 Settings
0478-131-3050-A