Idiomas disponibles
Idiomas disponibles
installation of optional air panel: p-ap160na1 / p-ap160nae
false ceiling
C A u T I O N
•
If tighten long screws insufficient, may cause something
wrong as below.
Air Leakage
Smudge
•
If any gap has even though tighten long screws sufficient, re-
adjust the height of indoor unit.
No gap shall exist
•
It's able to adjust the indoor unit height by using wrench from
the corner pocket.
Wrench
•
Too considerable adjustment of height cause dewing from
drain-pan.
•
Do not turn the air louver by hand. If moved, the louver me-
chanism would be damaged.
8.2.1 Attachment of Corner Pocket Cover
Attach the corner pocket covers after the air panel is mounted
completely.
a. Catch the band at the rear side of the corner pocket cover
onto the projection at the air panel as shown.
16
indoor unit
Corner
Long screw
panel
Dewing
PmmL0223A rev.0 - 05/2012 - P5415035
Fixing plate
(indoor unit)
Band
Fixing hook
b. Insert and push the fixing hooks (2 portions) at Ⓐ to the
air panel and insert and push the fixing hook (1 portion) at
Ⓑ to the air panel.
Attachment of corner pocket cover with motion sensor
of air panel model P-AP160NAE
The corner pocket cover with motion sensor can be attached to
any of corners. Determine the attaching place as user's request.
a. Connect the relay wire (attached in the air panel) to CN10
in the electrical box.
Band
Run the relay wire to the corner pocket cover with motion sensor
through the top of fixing plate for the indoor units. Set a length of
100mm to 200mm from the indoor unit to the relay connector.
Projection
Fixing hook
A
A
B
A
Projection
Air panel
Corner pocket
Relay wire
Corner pocket cover
with motion sensor
Relay
connector
B
Plastic band
Wiring cover
Plastic band
