7/ Diagnostic Of The Failures - Pool Technologie MINISALT Manual De Usuario

7/ DIAGNOSTIC OF THE FAILURES

1
WINTERIZING
A1
This code means that the device has detected a production anomaly.
Causes
Lack of Chlorine production is stopped.
water Check full and constant flow of water in the cell.
Chlorine production is damaged or noexistent.
Lack of
Check the salt rate in the pool with your usual analysis kit. It has to be greater than 3 kg/m
salt
and ideally at 5.
Controller Chlorine production is stopped.
problem You have to contact a professional so that he proceeds to the repair of the Controller.
Chlorine production is damaged or noexistent.
1/ Check visually that the cell is not scaled (to descale, see §6.2).
Cell 2/ Check that the connexions to the borders of the cell are not oxidized and well squeezed.
problem 3/ In most of cases, this code shows that your cell is totally used and/or scaled and cannot
produce chlorine.
You have to contact a professional to proceed to the replacing of its.
If this alarm starts in an inappropriate way (defect of the flow sensor for example), it is possible to deactivate it with the
code AL in the CHLORINATION menu (see § 4.2).
Originally, the alarm A1 is deactivated by default. If necessary, this function invites the user to activate
manually this order.
A shock chlorination and a strong correction of the pH by adding acid or soda in skimmers risk activating the
alarm without any reason.
A2
This code triggers the short circuit security.
Causes
Chlorine production is stopped.
Bad
Check on the cell if the nut is correctly tightened on the cable terminal.
connection
Chlorine production is stopped.
Controller
If an electronic component of controller is defective, You have to contact a professional to
problem
repair the controller.
MINISALT – PAPI004086MULTI – FR/EN/DE/IT/ESP/PT – Rev.05.16
Explanations/Remedies
Explanations/ Remedies
3
13