Idiomas disponibles
Idiomas disponibles
FO-22MX88
HDMI
IR EXT
OUT 1
OUT 2
IN 1
IN 2
IN 3
REMOTE CONTROL
You can control the matrix remotely in 2 different ways:
-
via TCP/IP communication - GUI
-
via RS-232 communication
TCP/IP COMMUNICATION - GUI
Connect the matrix to a PC using Cat 5e/6 cable or via a router.
The default values of the FO-22MX88 matrix are as follows:
-
IP address: 192.168.1.100 (default)
-
Subnet mask: 255.255.255.0
-
Default Gateway: 192.168.1.1
It is possible to check the IP address of the matrix from the front button set of the matrix and modify the
DHCP settings:
1.- Press the MENU button three times and the display will show HDCP ON IP -> 192.168.1.100.
2.- This second line shows the IP address. In addition, it is possible to enable or disable the DHCP
function on this screen by pressing the UP/DOWN buttons. The display will show HDCP ON or
DHCP OFF.
Set the PC IP in the same range as the matrix to operate the computer over the TCP/IP communication
protocol. To do this, go to the properties of your network card and configure a fixed IP (for example,
192.168.1.101).
Once the PC is set, you can enter the IP address of the matrix (192.168.1.100) in your browser to connect
to it. The system will request for a user name and a password. Once you have accessed the matrix you
can add another user who is not an administrator. By default the administrator user will have the following
credentials:
-
USERNAME: admin
-
PASSWORD: admin
From this point on, you can control the operation of the matrix. In the upper right corner you can find out
the user of the session, log out LOG OUT and activate the StandBy mode of the matrix with the POWER ON
button or switch on the matrix with the STANDBY button.
Go to the 7 side menu options to make the following settings:
1.- STATUS: displays the basic information: matrix model (a), firmware version (b), and network card
information (c).
DVD
BLUE-RAY
HDMI
HDMI
HDMI
L / R
OUT 3
OUT 4
OUT 5
OUT 6
OUT 7
OUT 8
IN 4
IN 5
IN 6
IN 7
COAX
OUT 1
OUT 2
OUT 3
OUT 4
OUT 5
IN 8
OUT 1
OUT 2
OUT 3
HDMI
HDMI
IN 3
IN 7
- 5 -
CONTROL REMOTO
TCP/IP
OUT 6
OUT 7
OUT 8
CONTROL
OUT 4
OUT 5
OUT 6
OUT 7
HDMI
HDMI
IN 6
IN 3
EN
VIA TCP/IP
RS-232
DC 12V
OUT 8
12 V CC
