Idiomas disponibles
Idiomas disponibles
ATTENTION!
►
This charger can only charge the fol-
lowing batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1 .
►
An up-to-date battery compatibility list can
be found at www .lidl .de/akku .
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or
a similarly qualified person .
Use
Charging the battery pack
CAUTION!
►
Always unplug the appliance before you
remove a battery pack from or connect a
battery pack to the dual high-speed charger .
NOTE
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C .
If a lithium-ion battery is going to be stored
for an extended period, the charge level must
be checked at regular intervals . The optimum
charge level is between 50% and 80% . The
storage climate should be cool and dry, and
the ambient temperature should be between
0°C and 50°C .
■
4
│
GB │ IE
♦
Slide one or two battery packs into the dual
high-speed charger
♦
Insert the power plug into the socket .
♦
The charge level of the respective battery pack is
indicated by the corresponding LEDs
and the adjacent illustrations:
LED 1
flashes: The battery pack is empty
.
LED 2
flashes: The battery pack is 1/3
charged .
LED 3
flashes: The battery pack is 2/3
charged .
All LEDs
/ /
battery pack is fully charged .
ATTENTION!
♦
If all of the LEDs
the battery pack has overheated and cannot
be charged .
♦
When charging is complete, disconnect the
dual high-speed charger
and remove the respective battery packs .
♦
You should always switch the dual high-speed
charger
off for at least 15 minutes between
successive charging processes . To do this,
disconnect the power plug from the mains
power socket .
Cleaning
CAUTION!
►
Always unplug the charger before cleaning it .
►
Do not clean the charger with water .
■
Clean the appliance with a dry or slightly
moistened cloth .
.
/ /
light up permanently: The
/ /
flash, this means
from the mains
PDSLG 20 A1
