Idiomas disponibles
Idiomas disponibles
Insertion of silica gel
Before sealing the Case, insert the accessory silica gel bag (for prevention
of fogging) between the bottom of the camera and the Case. Insert the bag
with the glued longer side to the inside.
Pay attention to the orientation.
CAUTION
： ・Insert the silica gel all the way at the specified location and
with the specified orientation. When the orientation is not
correct, the silica gel bag will be caught when the Case is
sealed and water leakage will be caused.
・ Attempting to seal the Case with the bag inserted only part of
the way will cause the silica gel bag to get caught by the O-ring
and water leakage will occur.
・ Once silica gel has been used, the moisture absorption
performance will be impaired. Always exchange the silica
gel when the Case is opened and closed.
Check the loading status.
Always perform the following final checks before sealing the Case.
・Has the silica gel been inserted all the way at the specified position?
・Has the O-ring at the Case opening part been installed properly?
・Are the O-ring and the O-ring contact surface on the front lid free of dirt and
other foreign matter?
E-17
