Idiomas disponibles
Idiomas disponibles
chocks. Follow the simple directions for easy cutting.
When the log is supported along its entire length (Fig.14), it
is cut from the top (overbuck).
When the log is supported on one end (Fig.15), cut 1/3 the
diameter from the underside (underbuck). Then make the
finished cut by overbucking to meet the first cut.
When the log is supported on both ends (Fig.16), cut 1/3
the diameter from the top (overbuck). Then make the
finished cut by underbucking the lower 2/3 to meet the first
cut.
When cross-cutting/bucking on a slope always stand on the
uphill side of the log (Fig.17).
When "cutting through", to maintain complete control,
release the cutting pressure near the end of the cut without
relaxing your grip on the chain saw handles.
Don't let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move the
chain saw. Always stop the motor before moving from tree
to tree.
CHARGING THE BATTERY PACK
WARNING:
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
NOTE:
Charge batteries at a ambient temperature of 32°F-104°F
(0°C-40°C) and always store batteries at a ambient
temperature of 32°F-77°F (0°C-25°C).
1. Charge the Lithium-Ion battery pack only with the correct
charger.
2. Connect the charger to a power supply, the light indicator
of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger.
4. Insert the battery pack into the charger, the light indicator
of the charger turns green and it flashes (Fig.18).
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
WWW.SENIXTOOLS.COM
CHARGING INDICATOR
Press the light button on the battery pack to check whether it
needs to charge (Fig.19) .
Lights
Lighted
Off
Blinking
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery cool
before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
Status
The battery is at full
capacity.
The battery is at 75%
capacity.
The battery is at 50%
capacity and requires
charging.
The battery is at 25%
capacity and requires
charging soon.
The battery is less
than 5% capacity
and requires charging
immediately.
19 - EN
