Idiomas disponibles
Idiomas disponibles
ASSEMBLY
1. Unpack all parts and lay them on a flat, stable surface:
2. Remove all packing materials and shipping devices, if
applicable.
3. The scope of delivery varies depending on the country
and purchased variant:
Model of CSX2-M1-0
• Chainsaw x1
• Instruction manual x1
• Guide bar x1
• Guide bar cover x1
• Saw chain x1
• Wrench x1
4. If you find that parts are missing or show damage do
not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to
people and property.
5. Ensure that you have all the accessories and tools
needed for assembly and operation. This also includes
suitable personal protective equipment.
NOTE:
CSX2-M1 includes the charger and the battery pack.
CSX2-M1-0 does not include the charger and the battery
pack.
WARNING:
Wear protective gloves for this assembly work
and always lay the product on a flat and stable
surface while assembling.
Follow the assembly instructions step-by-step
and use the pictures provided as a visual guide
to easily assemble the product!
Do not insert the battery pack before the power
tool is completely assembled or adjusted!
INSTALLING THE SAW CHAIN
AND THE GUIDE BAR
WARNING:
Ensure the battery pack is removed from the
chainsaw before attaching the bar and chain.
1. Totally loosen the side cover nut counterclockwise with
the assistance of wrench. Then remove the side cover
(Fig.2).
2. Loop the new saw chain into the slot of the guide bar
according to the provided figure (Fig.3).
EN - 16
3. Install the guide bar and the saw chain on the drive
sprocket (Fig.4). Adjust the tensioning gear when the
guide bar and saw chain can not be mount over the drive
sprocket (Fig.5).
4. Pull the chain around the guide bar with your gloved
hand or using auxiliary tools to make sure it can run
smoothly.
NOTE:
It is still recommended to check for smoothness of the saw
chain before operation even after using it for a period of
time.
5. Replace the side cover and slightly tighten the side
cover nut (Fig.2). Do not tighten too much. Meanwhile,
protect the saw chain from sliding out.
6. Twist the tensioning gear till the saw chain can be lifted
by 2-3 mm from the center of the guide bar.
7. Fully tighten the side cover nut clockwise (Fig.2).
NOTE:
After a short period of use, allow the chain to cool, remove
the battery and check the tension again.
BAR AND CHAIN OIL FILLING
WARNING:
Bar and chain oil prevents premature wear.
Never operate the chainsaw if oil is not visible.
Check oil level frequently and fill as needed.
NOTE:
Bar and chain oil is required to properly lubricate the guide
bar and saw chain. The chainsaw is equipped with an
automatic oiler that deposits oil on the bar and chain when
running, keeping them properly lubricated.
1. Place the chainsaw on its side on a firm, flat surface, so
that the oil tank cap is on top.
2. Clean any debris from the cap area.
3. Remove the oil tank cap (Fig.6).
4. Carefully pour the bar and chain oil into the tank.
5. Replace the cap and make sure oil is visible in the tank.
INSTALLING/REMOVING THE
BATTERY PACK
To install:
Slide the battery pack to the battery docking port on the
WWW.SENIXTOOLS.COM
