Idiomas disponibles
Idiomas disponibles
product until it clicks (Fig.7).
To remove:
Press the unlock button on the battery pack and slide the
battery pack out.
OPERATION
WARNING:
Never operate a chain saw that is damaged or
improperly adjusted or that is not completely and
securely assembled. Be sure that the saw chain
stops moving when the power control system
trigger is released. Never adjust the guide bar or
saw chain when the engine is operating.
TESTING THE CHAIN BRAKE
This chainsaw is designed with a function of chain brake
on the guard, which stops both the motor and the motion of
the chain when kickback occurs. The chain brake can be
activated by pushing the guard forward as the saw rotates
backward during kickback. Make sure the chain brake is
working before using the chainsaw.
To check brake operation (Fig.8):
• Place the saw on a firm, flat surface.
• Start the saw briefly.
• Push the guard forward to activate the function of chain
brake. A properly functioning chain brake stops the motor
and saw chain immediately. If the motor and saw chain do
not stop immediately, have the chain brake checked at an
approved service location.
• Release the switch trigger.
• Return to operating position.
PRIMING THE OILER
WARNING:
Keep hands, clothing, and hair away from the
drive sprocket when priming the oiler.
NOTE:
Prime the oiler before the first use or after being stored for
a long time.
It is essential to fill with oil before use. Operating the
chainsaw without bar and chain oil will result in damage to
the chain saw. The chain is automatically lubricated with oil
WWW.SENIXTOOLS.COM
during operation via the oil outlet (Fig.9).
1. Insert the battery.
2. Run the chainsaw for about two minutes.
3. Remove the battery.
4. Remove the side cover.
5. Check for oil on the bar.
TENSIONING THE SAW CHAIN
NOTE:
Check the tension between the saw chain and the guide bar
before every starts of the chainsaw.
WARNING:
Only tension the saw chain when the chain is
cool. A hot chain may contract and damage the
guide bar or chain as it cools.
1. It is no need to remove the side cover for adjusting the
chain tensioning gear (Fig.5). Just loosen the side cover
nut slightly by a wrench to unlock the guide bar and saw
chain which completely locked during operation.
2. Twist the tensioning gear till the chain come to a suitable
tension status. The correct chain tension is reached
when the saw chain can be lifted by 2-3 mm from the
center of the chain bar.
3. Tighten the side cover nut after adjustment.
NOTE:
If the chain is still loose when the saw is at maximum
tension, replace the chain.
SWITCHING ON/OFF
WARNING:
Follow the instructions in your operator's manual
for starting the chain saw and control the chain
saw with a firm grip on both handles when it is in
operation. Always hold the chain saw with your
right hand on the rear handle and your left hand
on the front handle. Keep handles dry, clean,
and free of oil.
Ensure the guard is at operation position. If not, turn it back
to the operation position.
Keep the trigger lock-out being pressed at first, then
squeeze the switch trigger to start the product. Just release
the trigger lock-out once the chainsaw starts. To turn off the
chainsaw, release the switch trigger (Fig.10).
17 - EN
