Idiomas disponibles
Idiomas disponibles
Maintenance and cleaning
Before performing cleaning, adjusting, accessories
changing, repairing and maintenance work, remove the
battery pack from the power tool.
Replace worn out or damaged parts immediately, so
that the power tool is always in a safe operating
condition.
Cleaning:
Always keep the power tool clean and dry, free from oil,
lubricants or grease.
thoroughly cleaned after each use.
Do not use aggressive cleaning products. These
products
may
damage
compromising the safe operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official distributor.
Keep all screws and bolts well tightened in order to
ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately and correctly.
Use only VITO-approved tools for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the cordless angle
grinder. If in doubt, if you lack knowledge or resources,
you should contact an official distributor.
Technical assistance
The cordless angle grinder should only be serviced by
the brand's technical assistance center, or other
qualified personnel, replacing any necessary parts with
original ones.
The power tool must be
plastics
and
metals,
ASSEMBLY INSTRUCTIONS
Auxiliary handle
The auxiliary handle (11) can be mounted in two
different positions to adapt the power tool to the work
to be done and make easier its handling.
1. Insert the auxiliary handle bolt into one of the
threads on the metal gear head;
2. Screw the auxiliary handle in clockwise until it is fully
tightened in place.
Installing and adjusting the disc guard
The position of the disc guard can be adjusted to suit
the working conditions. The disc guard must be fitted on
the appliance so that the closed side of the guard always
points toward the operator.
1. Install the disc guard (12) with the protrusion on the
guard band aligned with the notch of the gear head
(4);
2. Turn the disc guard according to the desired position;
3. Tighten the guard locking tab (3). If the guard is not
tightened properly, adjust the bolt;
4. To remove the disc guard, follow the installation
procedure in reverse.
Installing the disc
1. Make sure that the disc guard (12) is fitted;
2. Insert the inner flange (2) onto the spindle. Ensure
that the flange is placed on the spindle;
3. Insert the disc (1) into the inner flange. Make sure the
disc is correctly installed;
4. Screw the outer flange onto the thread of the spindle,
with the protruding area facing against the disc;
5. Press the spindle lock button (5) and turn the disc by
hand until it locks. Keep the spindle lock button
pressed in and tighten the outer flange with the
supplied spanner;
6. Perform a test, at maximum speed, to check the
correct installation of the rotating accessory;
7. To remove the disc, follow the installation procedure
in reverse.
Wear
protective
accessories.
gloves
when
installing
29
