Idiomas disponibles
Idiomas disponibles
Before you start operating
Individuals who have not read the instruction manual
and are not familiarized with how to operate the angle
grinder must not use it.
To ensure that you work with the power tool safely, you
should take into account a few precautions and
procedures before start-up:
▪ Inspect the power tool before each use. Check that
all attachable accessories are assembled correctly
and in good condition. If there is damage or excessive
wear, replace them;
▪ Check that all bolts and screws are properly
tightened. Regular inspection is important to ensure
safety issues and the performance of the power tool;
▪ After the attachment' assembly and before using the
power tool, test it at full speed with no load for a
while. Check for moving parts misalignment or any
other condition that may affect the angle grinder
operation. Check that all moving parts run smoothly,
without abnormal noises;
▪ Check that the safety devices are in perfect condition
and work properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or
worn out;
▪ If the ON/OFF switch is damaged or does not allow
the operation of the tool to be controlled, it must be
repaired or replaced in order to prevent any
accidental start;
▪ Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to
a rotating part of the power tool may result in
personal injury;
▪ While using the angle grinder on metal parts, sparks
will be produced. Therefore, check that nobody is in
danger zone and that there are no flammable
materials near the working area;
Make all adjustments and work necessary for the
correct assembly of the power tool if you have any
questions or difficulties, contact your official dealer.
While operating
Keep third parties away from the power tool's area
of operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to
300 lux light), thus decreasing the risk of accidents.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves and helmet properly reduces the risk of injury.
Wear a heat-resistant protective apron if particles that
may be hot or glowing are projected.
Anyone coming into the work area must wear personal
protective equipment. Fragments of workpiece may fly-
off and cause injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler
suit. Do not wear loose clothing or jewelry. Keep hair,
clothing and gloves away from moving parts.
Never use the power tool if the safety devices are
missing, inhibited, damaged or worn out;
The following precautions and procedures should also
be followed to avoid accidents:
▪ The rotating accessories speed of the angle grinder
must be at least equal to the maximum speed stated
in the technical specifications;
▪ When operating the angle grinder, adopt a stable
position and always keep your balance.
appliance firmly to ensure continuous operation and
withstand unexpected situations, such as kickback;
Hold the
27
