Idiomas disponibles
Idiomas disponibles
Working with the tool
CAUTION:
Keep all parts of the body away
from the saw chain when the motor is operating.
CAUTION:
Hold the tool firmly with both
hands when the motor is running.
CAUTION:
Do not overreach. Keep proper
footing and balance at all times.
CAUTION:
When cutting through branches, be careful
not to lose your balance due to the weight of the tool head.
CAUTION:
Always keep escape route in case
a cut branch falls towards the operator.
CAUTION:
Never use the tip of the guide bar
for cutting. Otherwise, dangerous kickback may
occur, and it may result in personal injury.
NOTICE:
Never toss or drop the tool.
NOTICE:
Do not cover the vents of the tool.
NOTICE:
Do not force the tool. Otherwise, it may
damage the tool.
Stand on a stable surface, and hold the tool away from
the branches so that the angle of the tool becomes 60°
or less against the horizontal ground.
Fig.37
► 1. 60° or less
Start the tool, and then press the saw chain onto the branch lightly.
When cutting long branches, in order to control the drop position
of cut branches, divide the branch in sections and cut the branch
from the tip. Pay attention to the falling branches since they may
bounce in the direction of the operator after hitting the ground.
Fig.38
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
Fig.39
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
Fig.40
Carrying tool
1
Before carrying the tool, always remove the battery
cartridges from the tool, then attach the guide bar cover,
and then shorten the pipe. Also, cover the battery car-
tridge with the battery cover.
Fig.41
► 1. Guide bar cover 2. Battery cover
18 ENGLISH
1
1
2
2
