Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
FILTER ASSEMBLY
Inspect and clean the filters periodically. This should be
done every month or more depending on usage. If there is
a decrease in wash performance or dishes feel gritty, this is
also an indication the filters need to be cleaned.
ULTRA-FINE FILTER ASSEMBLY
To clean the Ultra-Fine Filter assembly, remove the bottom
rack. Twist the Ultra-Fine Filter assembly counterclockwise
and lift to remove for cleaning. Rinse filter with warm soapy
water and use a sponge to carefully remove any stubborn
particles.
For models with a 2-piece Ultra-Fine Filter assembly with
an additional Filter Basket for food particles, twist the Filter
Basket in the counterclockwise direction to unlock it from
the Ultra-Fine Filter assembly. See directional arrows on the
bottom of the Filter Basket. Pull the Filter Basket to remove
from the assembly, throw away any food particles, rinse with
warm soapy water, and use a sponge to remove any stubborn
particles.
2-piece - Ultra-fine Filter assembly with additional Filter Basket
(on some models)
Once cleaned, replace Filter Basket back into the Ultra-Fine
Filter assembly and twist it clockwise to lock into place.
49-4000207 Rev 2
FINE FILTER
To clean the Fine Filter (mesh plate), remove the bottom
rack. Remove the Ultra-Fine Filter.
Lift the Fine Filter up and out from under the two rear
retaining tabs. Rinse filter with warm soapy water. Scouring
pads or brushes can scratch the filter surface but a soft
brush or sponge may be needed to remove stubborn soils
or calcium deposits caused by hard water. Once cleaned,
replace the Fine Filter making sure it goes under the two rear
retaining tabs. Replace the Ultra-Fine Filter.
Fine
Ultra-Fine
Filter
Filter
PROTECT AGAINST FREEZING
If your dishwasher is left in an unheated place during the winter,
ask a service technician to:
1
Turn off electrical power to the dishwasher. Remove fuses or
trip circuit breaker.
2
Turn off the water supply and disconnect the water inlet line
from the water valve.
3
Drain water from the water inlet line and water valve. (Use a
pan to catch the water.)
4
Reconnect the water inlet line to the water valve.
Spray
Arm
19
