Idiomas disponibles
Idiomas disponibles
Included in delivery
(a)
Fully automatic coffee machine
(b)
Installation instructions
(c)
Assembly bracket
(d)
Transformer mount
(e)
Spacers
(f)
7 fastening screws (silver)
(g)
2 fastening screws (long/black)
(h)
1 sleeve (black)
(i)
2 fastening screws (short/black)
(j)
2 sleeves (white)
(k)
Transformer
(l)
Hose guide
(m)
Hose clamp
(n)
Fastening screws
(o)
Hinge dampers
General information for water and
drain water connection
The appliance should not be installed more than 39
(1000 mm) away from a drain water connection. The
water connection can be extended by 118
with a special pipe (part number 00357081).
A shut-off valve must be installed between the water
inlet hose and the domestic water connection so that
the water supply can be turned off if necessary. The
shut-off valve, water inlet and outlet house must be
freely accessible following installation.
The appliance complies with the international standards
and may not be connected without a backflow preventer.
A tap with a ¾" (26.4 mm) screwed connection is
required for connection. If not available, the appliance
may be connected only by an approved technician.
The water quality must comply with the drinking water
regulations of the individual country in which the
appliance is operated.
The connection to the domestic water supply and all
equipment and devices used to supply the water to the
appliance must comply with the applicable provisions of
the individual country.
The drain water connection must be min. 150 mm below
the lower edge of the appliance.
The drain water hose must not be extended.
If the installation location of the appliance is too far
away from the main drainage point (siphon), the
drainage system (domestic installation) must be
adapted.
⁄
"
3
8
7
⁄
" (3000 mm)
64
13
