SWS96285RD
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all
cautions and warnings included in the shop manual. Read and follow all instructions carefully. This product is only designed to function properly on
specific vehicle applications. Please verify that the vehicle requirements match the product specifications and application notes for this part.
STEP 29: Lower the vehicle.
STEP 30: Position sway bar at 10 degrees above
horizontal. NOTE: Use an angle finder for this step.
Many smart phones can also perform this function.
STEP 31: Adjust pre-assembled stabilizer links
equally to correct length. Taller vehicles may require
the included longer connecting rods to be used.
CAUTION: Be sure to never adjust jam nut less than
5/8" from end of either connecting rod to maintain
proper thread engagement.
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto
technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in
property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Dorman Products, Inc. | Corporate Office and Customer Service: 1-800-523-2492
©2022 No reproduction in whole or in part without prior written approval.
INSTALLATION INSTRUCTIONS:
STEERING WOBBLE KIT
Use longer threaded rod on
vehicles with a 1.5" lift or higher.
Always ensure even thread
engagement at both ends and a
minimum of 5/8" thread length
remains engaged.
Disclaimer:
10°
Horizontal
SWS96285RD_Instructions
16