Dorman SWS96285RD Instrucciones De Instalación página 15

SWS96285RD
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all
cautions and warnings included in the shop manual. Read and follow all instructions carefully. This product is only designed to function properly on
specific vehicle applications. Please verify that the vehicle requirements match the product specifications and application notes for this part.
STEP 26: Install stabilizer link bushing isolators onto
the bullet shaft.
STEP 27: Install the U-brackets to the sway bar.
Threaded side of U-brackets should be oriented so
they face inboard. Orientation of the U-brackets will
depend on ride height. Taller vehicles (3"–4" of lift)
will require the brackets to be installed on the bottom
of the sway bar. Shorter vehicles require mounting the
U-brackets on top of the sway bar.
STEP 28: Install 10mm bolts through sway bar and
U-bracket from the bottom. Attach corresponding
nuts and tighten to 40 ft-lbs.
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto
technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in
property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Dorman Products, Inc. | Corporate Office and Customer Service: 1-800-523-2492
©2022 No reproduction in whole or in part without prior written approval.
INSTALLATION INSTRUCTIONS:
STEERING WOBBLE KIT
Threaded hole
side should face
inboard of vehicle.
Disclaimer:
Mount bullet facing inboard on
vehicle with isolator bushing
pressed fully onto shaft.
Tighten with lock pin hole
running horizontally.
SWS96285RD_Instructions
15