Probuilder 43670 Manual De Instrucciones página 48

Explanation of the compressed air
� tting
1. Manometer (pressure in tank)
2. Pressure reducer
Setting up the equipment
If the compressor is to be set up against a
wall, a minimum distance of 30 cm between
the compressor and the wall should be
maintained to ensure proper cooling.
48
1
2
Transport
Always transport the equipment in an
upright position. Avoid bumping against the
� ttings.
Switching the compressors ON and OFF:
On all units the ON/OFF switch is located at
the top of the pressure switch covers (see
with illustrations). The switch position is
marked "O" and "I". When inserting the plug,
the switch must be in the "O" position. Do not
switch on until the plug has been inserted.
When switching off , � rst set the switch to
"O", then remove the cable from the socket.
Generally, never switch off the device by
pulling out the connector plug, otherwise
the integrated start-up relief will not be
eff ective.
Using compressed air devices and
tools
Please observe the air consumption
speci� cations of the respective
manufacturers. Check whether the power
of your compressor is suffi cient to operate
these devices. The air consumption values
listed below can serve as a reference and
guideline.
Pressure vessel volume (in liters) and
theoretical suction capacity l/min
Tank (I)
Air � ow (l/min)
24
172