Connection/Installation
Cautions
• Do not install this unit in a car that has no ACC
position. The display of the unit does not turn off
even after turning the ignition off, and this causes
battery drain.
• Run all ground (earth) leads to a common
ground (earth) point.
• Do not get the leads trapped under a screw or
caught in moving parts (e.g., seat railing).
• Before making connections, turn the car ignition
off to avoid short circuits.
• Connect the power supply leads to the unit and
speakers before connecting it to the auxiliary
power connector.
• Be sure to insulate any loose unconnected leads
with electrical tape for safety.
• Choose the installation location carefully so that
the unit will not interfere with normal driving
operations.
• Avoid installing the unit in areas subject to dust,
dirt, excessive vibration, or high temperature, such
as in direct sunlight or near heater ducts.
• Use only the supplied mounting hardware for a
safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with other stereo
components, the amperage rating of the car circuit to which
the unit is connected must be higher than the sum of each
component's fuse amperage rating.
Note on installing in cars with a start-stop system
The unit may restart when starting the engine from start-
stop. In this case, turn off the start-stop system of your car.
Note on installing in cars with electric parking brake
system
For cars with electric parking brakes, some related functions
(such as video blocking function) may not work properly.
Mounting angle adjustment
Adjust the mounting angle to less than 30°.
Parts List for Installation
Power supply leads (1)
Microphone (1)
Double-sided tape (1)
Adhesive tape (2)
Mounting sleeve (1)
Release key (2)
• This parts list does not include all the package
contents.
• The mounting sleeve is attached to the unit
before shipping. Before mounting the unit, use
the release keys to remove the mounting
sleeve from the unit. For details, see "Removing
the mounting sleeve" (page 15).
• Keep the release keys for future use as they are
also necessary if you remove the unit from your
car.
Mounting screw
(5 × max. 9 mm
(
7
/
× max.
3
/
in)) (4)
32
8
Flat-mount base (1)
USB extension cable (2)
Cable tie (1)
Trim ring (1)
11
GB