Important Safety Instructions & Warnings - Hayward AquaVac 250 Manual De Usuario

IMPORTANT SAFETY INSTRUCTIONS & WARNINGS
When installing and using this electrical equipment, safety precautions should
always be followed, including:
WARNING!
- READ AND FOLLOW ALL INSTRUCTIONS in this manual and on the
equipment. Failure to do so could result in severe or fatal injuries.
- Ensure that children do not attempt to access cleaner while it is operating.
Closely supervise children and pets at all times to ensure they do not play with
the cleaner. This is not a TOY. Children should be kept out of reach from this
robot and its accessories.
- Never allow children to operate this product.
- This robot is not intended for use by someone with reduced physical, sensory
or mental capabilities or a lack of experience and knowledge unless they have
been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
- Make sure the robot is fully immersed in the water before operation. The
minimum water level required to operate the robot must reach above the swivel
head of the robot. Operating the robot when it is not immersed in the water
correctly could damage the unit and void the warranty as a result.
- Maximum operating depth in water is 3 meters (10 ft).
- Operating water temperature: 5˚C (41˚F) –35˚C (95˚F)
- Only use the detachable supply unit (external adaptor) provided with this robot
to charge the battery.
- Detachable supply unit (external adaptor)
- In the United States, the external adaptor must be connected only to a supply
circuit that is protected by a ground-fault circuit interrupter (GFCI). Contact a
qualified electrician if you cannot verify that the circuit is protected by a GFCI.
This GFCI should be tested on a routine basis. To test the GFCI, push the test
button. The GFCI should interrupt power. Push reset button. Power should be
restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the
GFCI interrupts power to the external adaptor without the test button being
pushed, a ground current is flowing, indicating the possibility of an electrical
shock. Do not use the external adaptor. Disconnect the external adaptor and
contact the manufacturer for assistance.
- In Europe, Australia and New Zealand, the cleaner power supply unit must be
supplied through a residual current device (RCD) having a rated residual
operating current not exceeding 30 mA. Contact a qualified electrician if you
cannot verify that the circuit is protected by a RCD.
SAVE THESE INSTRUCTIONS
4