4. Insert the plug into a duly installed 230 V/50 Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
COOL SHOT (Cold Air)
Switch-off
•
After use shift the switch to position „0" and pull out the plug. Leave the device to cool
before putting it away! To this purpose place the device on one side of the housing or
hang it up by the suspension lug.
•
Before cleaning remove the mains lead from the socket.
•
Clean the housing with a soft, dry cloth without additives.
WARNING: The device must never be immersed in water!
Mains Cable
•
The mains cable should only be wound up loosely.
•
Never tie the cable tightly round the device, as over time this may result in the cable
breaking.
•
Check the mains cable regularly for damage.
Air Intake Grill
•
Please clean the grill on the air intake side of the hairdryer regularly in order to avoid
excessive temperatures as a result of heat accumulation.
•
Remove any dirt that is present. If necessary, a fine brush can be used.
-HT 3332.indd 31
Level 0:
off
Level 1:
medium airflow and medium temperature
Level 2:
strong airflow and high temperature
COOL
With this switch you can stop the heating process. Hold the
button down in this position according to the desired interval
length. When the button is released it returned automatically
to the initial position.
Cleaning and care
GB
31
05.10.2009 14:40:32 Uh
