Function; Setting The Flow Duration; Setting The Range; Hygiene Flushing - Franke AQCT0031 Instrucciones De Montaje Y Uso

13. Function

☞
The remote control (not included, see Accessories
select the operating mode time-controlled/body reflection.
Triggering time-controlled water flow
13.1 Allow your hand to approach the sensor.
• Water flows.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again.
☞
The flow duration has been factory set to 30s.
Triggering body-reflection controlled water flow
13.2 Allow your hand to approach the sensor.
• Water flows.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again
or
– after leaving the sensor range.

14. Setting the Flow Duration

You can adjust the flow time from 10 seconds to 5 minutes seconds using the
remote control (not included, see Accessories

15. Setting the Range

The range for body reflection can be set with the remote control (not included, see
Accessories Chapter

16. Hygiene Flushing

☞
At the factory, the hygiene flush function is set so that water flows for 10 seconds 24
hours after the flush was last activated.
The parameters for hygiene flushing can be set with the remote control (not
included, see Accessories
Intervals of 0, 8, 24, 48 or 72 hours can be set for hygiene flushing (0 = hygiene
flushing disabled). You can adjust the flow time from 10 seconds to 10 minutes.
25).
Chapter 25).
- 8 -
Chapter 25) can be used to
Chapter 25).