Commissioning; Function - Franke PRTR0009 Instrucciones De Montaje Y Uso

11. Commissioning

11.1 Open the water supply.
Caution!
First fill the hot water heater tank.
11.2 Insert the power plug in the socket.
☞
Observe the operating instructions for the hot water heater.

12. Function

12.1 Allow your hand to approach the sensor.
• Water flows.
12.2 Remove your hand from the sensor.
• Water flow stops automatically after a set flow duration.
☞
The range of the sensor and the flow duration can be adjusted with the optional
remote control (FAR Order No. 2000101087).
☞
Important!
Reflecting surfaces can influence the sensor. There is a risk of having permanent
reflections (see
"Auto-flush" function
Caution!
When the "Auto flush" function is used, the flow of water must be ensured.
• The "Auto-flush" function ensures that forced flushing takes place to exchange the
water in the tap lines after 24 or 72 hours of non-use.
• The "Auto-flush" function can only be switched on with the optional remote control
(FAR-Order-No. 2000101087).
• This function is switched off at the factory.
Chapter 13. for adjusting the sensor range).
[email protected] - www.hygiene-shop.eu
7