Idiomas disponibles
Idiomas disponibles
MN009533A01-AA
Chapter 10 : Scan
Chapter 10
Scan
Your radio scans through the programmed scan list for the current channel looking for voice activity
when you start a scan.
Your radio also performs dual-mode scan. If you are on a digital channel, and your radio locks onto
an analog channel, your radio automatically switches from digital mode to analog mode during the call.
If you are on an analog channel, and your radio locks onto a digital channel, your radio automatically
switches from analog mode to digital mode during the call.
Table 6: Scan Types
Type
Main Channel Scan
(Manual)
10.1
Turning Scan On or Off
Procedure:
Press the programmed Scan button.
If Scan is enabled, the following radio indications occur:
•
A positive tone sounds.
•
The green LED blinks.
If Scan is disabled, the following radio indications occur:
•
A negative tone sounds.
•
The green LED extinguishes.
10.2
Responding to Transmissions During Scanning
During scanning, your radio stops on a channel or group where activity is detected. The radio stays on
that channel for a programmed duration known as hang time. If you want to prioritize a channel, you
can enable the Priority Scan feature through the Customer Programming Software (CPS). Priority Scan
allows the radio to automatically receive transmission from talkgroups with higher priority.
Procedure:
1 Press the PTT button.
2 Wait for the Talk Permit Tone to end, and speak into the microphone.
3 To listen, release the PTT button.
26
Description
Your radio scans all the channels or groups in your scan list. When
scanning, your radio may, depending on the settings, automatically
start on the last scanned active channel or group, or on the channel
where scan was initiated.
