Dispensing Of Steam - Astoria JUN Manual De Uso

NOTE ( )
*
In some models, programming lever X is not fitted.
To enter the programming mode, press button
for a minimum of 5 seconds until all leds of the push-
button panel are lit. To confirm the dose press either
PROG.
button or the same dose button selected.
STOP
In other models, to access programming it is neces-
sary to use a special key switch.
To exit programming it is sufficient to wait a few
seconds.
COFFE DISPENSING
Put the coffee cup under the
dispensing spout
press the desired dose key, for
example and wait for the
coffee to be dispensed (LEDs
coming on);
to block the dispensing of
coffee in advance, press but-
ton again or button
in case of anomalies or block-
ing of the push/button panel,
use the manual switch (see
AEP version).
Do not remove the filter-holder from the delivery group during
coffee dispensing
38 160
of
X
PROG.
STOP
PROG.
;
STOP

Dispensing of steam

6.9
PROG.
STOP
Immerse the steam nozzle in the
liquid to be heated;
rotate the tap knob counter-
clockwise;
the quantity of steam will be
proportional to the opening of
the tap;
to stop the dispensing, rotate the
tap knob clockwise;
Carefully handle the steam spout through the specific scald-
preventing rubber grip (6).
Avoid contact with the steam nozzles, do not direct your hands or
other body parts towards the steam nozzle ends.
For optimal foaming, it is recommended to observe
the following simple rules:
heat only the amount of milk you intend to use; once
heated, it will have to be completely poured from the
jug and not heated again:
foam the milk starting from a temperature of about
4 °C.
6
USER manual