ADJUSTMENTS
Shift Cable
If the full range of speeds (forward and reverse) cannot be achieved,
refer to the figure to the right and adjust the shift cable as follows:
Place the shift lever in the fastest forward speed position (F6).
1.
2.
Loosen the hex nut on the shift cable index bracket. See Figure
21.
3.
Pivot the bracket downward to take up slack in the cable.
4.
Retighten the hex nut.
Drive Control
When the drive control is released and in the disengaged "up" position,
the cable should have very little slack. It should NOT be tight. Also,
if there is excessive slack in the drive cable or if the unit experiences
intermittent drive while using, the cable may need to be adjusted.
Check the adjustment of the drive control as follows:
1.
With the drive control released, push the snow thrower gently
forward. The unit should roll freely.
2.
Engage the drive control and gently attempt to push the snow
thrower forward. The wheels should not turn. The unit should not
roll freely.
3.
With the drive control released, move the shift lever back and
forth between the R2 position and the F6 position several times.
There should be no resistance in the shift lever.
4.
If any of the above tests failed, the drive cable is in need of
adjustment. Proceed as follows:
a.
Shut off the engine as instructed in the Operation section.
b.
Loosen the lower hex bolt on the drive cable bracket. See
Figure 22.
c.
Position the bracket upward to provide more slack (or
downward to increase cable tension).
d.
Retighten the lower hex bolt.
Chute
If the chute fails to remain stationary during operation, the pre-load of
the chute can be adjusted by tightening the hex nut found on the front
of the chute control head.
1.
To increase the preload, tighten the hex nut clockwise in ¼ turn
intervals. See Figure 23.
2.
If the chute directional control is difficult to crank, decrease the
preload by loosening the hex nut counterclockwise in ¼ turn
intervals.
SERVICE AND MAINTENANCE
19
Figure 21
Figure 22
Figure 23
