Idiomas disponibles
Idiomas disponibles
777x44366
REF: 751B278857
(Supplied By Manufacturer)
Place On Engine
On back Of Seat
20. 0
540
gr oss HP
777I23364
Place On Fender With
The PTO Side Next T o
The Pto And The Deck
Height Next T o The
Deck Height
777I22494
TRANSMISSION
BYPASS ROD
TO DRIVE (ENGAGE
TRANSMISSION) SLIDE UP
AND RELEASE
TO PUSH (RELEASE
TRANSMISSION) PULL ROD
OUT AND DOWN
777S30018
777x44365
LeFT
RIgHT
If BJ label Has
Important Em-
misions Infor-
mation Place
Label Here
777D14479
777S30503
DANGER
KEEP HANDS AND FEET AWAY .
DO NOT OPERATE MOWER
UNLESS CHUTE DEFLECTOR
OR ENTIRE GRASS CATCHER IS
IN ITS PROPER PLACE.
S30503
ASSEMBLE CHUTE DEFLECTOR TO THIS UNIT BEFORE OPERATING.
REF: Chute Label
Applied By Manufacturer
777I22470
CUTTING
SPEED
Labels
777X43688
Place On Gas T ank
Close T o Intake
DO NOT
USE E85 OR FUEL
CONTAINING MORE
THAN 10% ETHANOL
777S33583
DANGER
TO START
1. DISENGAGE BLADES/PTO, (POWER TAKE OFF)
2. ENGAGE THE TRACTOR'S PARKING BRAKE.
ROTATING BLADES CAUSE
3. ACTIVATE THE CHOKE CONTROL.
SERIOUS INJURY OR DEATH
4. TURN KEY TO START ENGINE. AFTER START RELEASE KEY & DEACTIVATE CHOKE
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE
BY PLACING THROTTLE TO FAST "RABBIT" POSITION.
AROUND
OPERATING MODES
• NEVER CARRY CHILDREN EVEN WITH BLADE(S) OFF.
NORMAL MOWING
• LOOK DOWN AND BEHIND BEFORE AND WHILE
YOU MUST DISENGAGE BLADES/PTO, (POWER TAKE OFF)
BACKING.
BEFORE TRAVELING IN REVERSE.
• MOWING IN REVERSE IS NOT RECOMMENDED.
REVERSE
CAUTION MODE
1. TURN KEY TO REVERSE CAUTION MODE POSITION.
2. DEPRESS REVERSE PUSH BUTTON. (RED INDICATOR LIGHT "ON")
WHEN RED LIGHT IS "ON" MACHINE CAN BE OPERATED
TO AVOID SERIOUS INJURY OR DEATH
IN REVERSE WITH MOWER BLADES ENGAGED.
IMPORTANT: MOWING IN REVERSE IS NOT RECOMMENDED.
• GO UP AND DOWN SLOPES, NOT ACROSS.
3. AFTER RESUMING FORWARD OPERATION, RETURN
• AVOID SUDDEN TURNS.
KEY TO "NORMAL MOWING" POSITION.
NOTE: IN BOTH MODES, WHEN OPERATOR LEAVES SEA T ,
• DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP .
ENGINE WILL STOP UNLESS PARKING BRAKE IS SET AND
BLADES ARE DISENGAGED.
• IF MACHINE STOPS GOING UPHILL, STOP BLADE(S)
AND BACK DOWNHILL SLOWLY .
BRAKE / CLUTCH
• KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND
P
PEDAL
SWITCHES, ETC.) IN PLACE AND WORKING.
• REMOVE OBJECTS THAT COULD BE THROWN BY THE BLADE(S).
Brake / Clutch Pedal On Drivers Left Side Of Rider
• KNOW LOCATION AND FUNCTION OF ALL CONTROLS.
IF UNIT STALLS WITH SPEED CONTROL IN HIGH SPEED, OR IF UNIT
• BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE
WILL NOT OPERATE WITH SPEED CONTROL LEVER IN A LOW SPEED
PLACING HANDS OR FEET NEAR BLADE(S).
POSITION, PROCEED AS FOLLOWS:
• BEFORE LEAVING OPERATOR'S POSITION, DISENGAGE
1. PLACE SHIFT LEVER IN NEUTRAL.
5. DEPRESS CLUTCH-BRAKE PEDAL.
BLADE(S), ENGAGE PARKING BRAKE, SHUT OFF AND
2. RESTART ENGINE.
6. PLACE SPEED CONTROL LEVER
REMOVE KEY .
3. PLACE SPEED CONTROL LEVER
IN DESIRED POSITION.
READ OPERATOR'S MANUAL
IN HIGH SPEED POSITION.
7. PLACE SHIFT LEVER IN EITHER
4. RELEASE CLUTCH-BRAKE PEDAL
FORWARD OR REVERSE AND FOLLOW
FULL Y .
NORMAL OPERATING PROCEDURES.
Operation Of This Equipment May Create Sparks That Can Start
Fires Around Dry Vegetation. A Spark Arrestor May Be Required.
The Operator Should Contact Local Fire Agencies For Laws Or
Regulations To Fire Prevention Requirements.
(qTY 2) 777D14490
On Lower Dash Area
both Sides
®
20 HP
ENGINE
AS RA TED BY ENGINE MANUFACTURER
777I23365
Place Lever Fully To Run
Position To Operate Unit.
PARK BRAKE OPERATION:
1st.
2nd.
Press
Move
Brake
Lever
Pedal
To Park
RUN
I23365 AC
P
PARK
BRAKE
ON
29
777I22773
Centered On Steering Wheel
With Only Half Of The Split
backing Removed For easy
Removal
NOTICE
STEERING WHEEL
MOUNTING HARDWARE
UNDER CAP, BEFORE
OPERATION SECURE
STEERING WHEEL TO
SHAFT ACCORDING
TO MANUAL
ReF. 777D14476 (qTY 3)
IN-MOLD ON bOTH SIDeS
OF HOOD SCOOp AND
FRONT gRILLe
777D14483
Lower Left Hood Side
place Over Weld Marks
777D14482
Lower Right Hood Side
place Over Weld Marks
777I22456
CHOKE
FAST
SLOW
