Idiomas disponibles
Idiomas disponibles
Arc force
Allows adjustment of the Arc force value in MMA.
Permits an adjustable energetic dynamic response in
welding, facilitating the welder's operations.
Parameter set as a percentage (%) of the welding current.
Minimum Off, Maximum 500%, Default 30%
7
Selection parameters
Allows entry to set up, the selection and the setting of
the welding parameters.
8
Welding process
Allows the selection of the welding procedure.
Electrode welding (MMA)
TIG welding
ARC AIR
9
Control methods
From front panel "internal"
From remote panel "external"
10
Measurements
Allows the real welding current or voltage to be dis-
played on 4.
Amperes
Volts
11
Welding process
Allows you to set the best arc dynamics, selecting the
type of electrode used:
Electrode welding (MMA)
Basic
Rutile
Acid
Steel
Cast iron
Electrode welding (MMA)
Cellulose
Aluminium
Selecting the correct arc dynamics enables maximum
benefit to be derived from the power source to achieve
the best possible welding performances.
Perfect weldability of the electrode used is not guaran-
teed (weldability depends on the quality of the consum-
ables and their preservation, the operating and welding
conditions, the numerous possible applications, etc.).
12
Signal cable input
Allows connection of the external devices such as
RC12, RC16.
24
3.2.1 Set up
Permits set-up and adjustment of a series of additional param-
eters for improved and more accurate control of the welding
system.
Entry to set-up: press key 7 for 3 sec. (the central zero on the
7-segment display confirms entry).
Selection and adjustment of the required parameter: rotate
the encoder until you display the numerical code for the
required parameter. By pressing key 7 at this point, you can
display the value set for the parameter selected and adjust it.
Exit from set-up: to quit the "adjustment" section, press key
7again.
To exit the set-up, go to parameter "O" (save and quit) and
press key 7.
List of set up parameters
0
Save and quit
Allows you to save the changes and exit the set up.
6
CH1 External parameter
Allows the management of external parameter (mini-
mum value, RC12, RC16).
7
CH1 External parameter
Allows the management of external parameter (maxi-
mum value, RC12, RC16).
9
Reset
Allows you to reset all the parameters to the default
values.
13
MMA Synergy
Allows you to set the best arc dynamics, selecting the
type of electrode used:
0 Basic
1 Rutile
2 Cellulose
3 Steel
4 Aluminium
5 Cast iron
Default 0
Selecting the correct arc dynamics enables maximum
benefit to be derived from the power source to achieve
the best possible welding performances.
Perfect weldability of the electrode used is not guaran-
teed (weldability depends on the quality of the consum-
ables and their preservation, the operating and welding
conditions, the numerous possible applications, etc.).
Alarm codes
10
System power supply alarm
12
Temperature alarm
20-24-25-26-27
Memory fault alarm
