Idiomas disponibles
Idiomas disponibles
Connection for TIG welding
- Connect (4) the earth clamp (2) to the positive socket (+) (3)
ofthe power source.
- Connect the TIG torch coupling (1) to the torch socket (6)
ofthe power source.
- Separately connect the torch gas hose connector (7) to the gas
main.
The protection gas flow can be adjusted using
the tap normally found on the torch (8).
Connection for deseaming ARC-AIR
- Connect (4) the earth clamp (2) to the negative socket (-) (6)
of the power source.
- Connect (1) the ARC-AIR holder (5) to the positive socket (+)
(3) of the power source.
- Connect separately the connector on the air (7) pipe to the air
supply.
3 SYSTEM PRESENTATION
3.1 General
The Genesis 503 CLS are constant current inverter power
sources developed for electrode (MMA), TIG DC with contact
ignition with reduction of short circuit current (TIG LIFT-START,
ARC-AIR).
3.2 Front control panel
1
Power supply
Indicates that the equipment is connected to the mains
and is on.
2
General alarm
Indicates the possible intervention of protection devices
such as the temperature protection.
3
Power on
Indicates the presence of voltage on the equipment
outlet connections.
4
7-segment display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
5
Main adjustment handle
Allows the welding current to be continuously adjusted.
This current is unchanged during the welding if the
power supply and welding conditions vary within the
ranges indicated in the technical characteristics.
In MMA welding, the presence of HOT-START and
ARC-FORCE ensures that the average output current
COMPRESSED
can be higher than the one set.
AIR
Allows adjustment of the selected parameter on graph 6.
The value is shown on display 4.
6
Welding parameters
The graph on the panel allows the selection and adjust-
ment of the welding parameters.
Welding current
Permits adjustment of the welding current.
Parameter set in Amps (A).
Minimum 6A, Maximum 500A, Default 100A
Hot start
Allows adjustment of the hot start value in MMA.
Permits an adjustable hot start in the arc striking phases,
facilitating the start operations.
Parameter set as a percentage (%) of the welding current.
Minimum Off, Maximum 500%, Default 80%
23
