Electrical Connection And Operation; Extension Cord; Electronic Control - Festool ROTEX RO 125 FEQ Manual De Instrucciones

Total Extension Cord
Lenght (feet)
Cord Size (AWG)
3.1

Electrical connection and operation

2.1
25 50 100 150
18 16 16

Electronic control

The mains voltage must correspond to the voltage
on the rating plate!
See the adjacent fi gure for connection and dis-
connection of the power cord.
connecting or disconnecting the power cord!
To switch on the tool, press the switch (2.1) down-
wards and forwards until it locks into place. To
switch off, press the switch downwards - this
releases the switch lock and it goes into the OFF
position.
If an extension cord is required, it must have suf-
fi cient cross-section to prevent an excessive drop
in voltage or overheating. An excessive drop in
voltage reduces the output and can lead to failure
of the motor. The adjecent table shows you the
correct cord diameter as a function of the cord
length for the RO 125 FEQ.
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
Note: The lower the AWG number, the stronger
14
the cord.
The tool has full-wave electronics with the
ELECTRONIC
following features:
Smooth start-up
The smooth start-up ensures jolt-free startup.
Speed adjustment
You can regulate the speed steplessly between
3000 and 6000 rpm using the adjusting wheel
(3.1). This lets you optimize the sanding speed to
suit the material.
Constant speed
The pre-selected speed remains constant whether
the tool is in operation or in neutral position.
Temperature control
To prevent overheating, the safety electronics
switch the tool off when it reaches a critical mo-
tor temperature. Let the tool cool down for ap-
6
Always switch the tool off before

Extension cord