Idiomas disponibles
Idiomas disponibles
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
SAfety WARNINGS ANd INStRuctIoNS: dRIllS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the tool.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
WARNING:
Always expect the stall. Grip the drill firmly with both hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
INStAllING ANd ReMovING tHe BAtteRy PAck fRoM tHe tool
cAutIoN:
before removing or installing battery.
to INStAll BAtteRy PAck:
Insert battery pack firmly into tool until an
audible click is heard as shown in figures c.
Ensure battery pack is fully seated and fully
latched into position.
to ReMove BAtteRy PAck:
Depress the battery release button as shown
in figure d and pull battery pack out of tool.
Shock hazard. Do not allow any liquid to get inside charger. Never
Drill may stall (if overloaded or improperly used) causing a twist.
Make certain the lock-off button is engaged to prevent switch actuation
C
D
8
