Idiomas disponibles
Idiomas disponibles
BAtteRy cAP INfoRMAtIoN
Battery storage and carrying caps are provided
for use whenever the battery is out of the tool or
charger. Remove cap before placing battery in
charger or tool.
WARNING:
contact exposed battery terminals. For example, do not place battery in aprons,
pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.
transporting batteries can possibly cause fires if the battery terminals
inadvertently come in contact with conductive materials such as keys, coins, hand
tools and the like. The US Department of Transportation Hazardous Material
Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes
(i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from
short circuits. So when transporting individual batteries, make sure that the battery
terminals are protected and well insulated from materials that could contact them and
cause a short circuit. NOTE: LI-ION batteries should not be put in checked baggage.
StoRAGe RecoMMeNdAtIoNS
1. The best storage place is one that is cool and dry away from direct sunlight and
excess heat or cold.
2. Long storage will not harm the battery pack or charger. Under proper conditions
LI-ION batteries, can be stored for 5 years or more.
cHARGING PRoceduRe
tHe BAtteRy PAck IS Not fully
cHARGed At tHe fActoRy. cHARGe
BAtteRy PAck foR At leASt 3 HouRS
BefoRe uSe.
The charger is designed to use standard
household 120 volt 60 Hz power.
1. Plug the charger into any standard 120
Volt 60 Hz electrical outlet.
2. Slide the charger onto the battery pack as
shown in figure B and let the battery pack
charge initially for 3-5 hours. After the initial
charge, under normal usage, your battery
pack should be fully charged in 3-5 hours.
a) During charging the green LED will illuminate.
b) When charging is complete the green LED will turn off.
3. Unplug charger, and remove the fully charged battery pack.
leAvING tHe BAtteRy IN tHe cHARGeR
The charger and battery pack can be left connected with the green LED glowing
indefinitely. The charger will keep the battery pack fresh and fully charged.
IMPoRtANt cHARGING NoteS
1. Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the
battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This
is a normal condition, and does not indicate a problem. To facilitate the cooling
of the battery pack after use, avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
fire hazard. do not store or carry battery so that metal objects can
B
7
Battery Cap
